
After some issues today with a HomeSeer installation that was unable to control a number of devices, checking through the log I found the following error messages –
Apr-07 19:32:55 Z-Wave Error Error, Exception in GetZWNetworkS: database disk image is malformed database disk image is malformed
Apr-07 19:33:04 Z-Wave Error HomeSeer UZB: The HomeSeer UZB interface did not respond to the request for the controller capabilities – it may be disconnected or malfunctioning (3).
Checking around online appeared to point to a log file that needed to be removed. However, this was not the case. Checking with HomeSeer technical support provided a fix –



Once I had completed the three simple steps above, rebooted the system, I was able to control my devices once again!